6200 Bearing Set w/ Dust Cap 21774 Dutton Lainson

Upgrade your trailer's performance with the 6200 Bearing Set with Dust Cap from Dutton Lainson. Engineered for durability and reliability, this set provides essential protection for your bearings against dust and debris, ensuring smooth and trouble-free towing on every trip. Trust Dutton Lainson for premium quality and peace of mind on the road.

• 3/4" spindle O.D.
• 1.781 outer hub I.D.
• LM11949 inner and outer bearing cone number
• LM11910 inner and outer cup number
• Identical to model 6500 except dust cap is included

Set Includes:

• (2) Bearings
• (2) Races
• (1) Grease seal
• (1) Cotter pin
• (1) Dust cap

Installation Instructions:
1. Removing wheel from hub will make hub less difficult to handle.
2. Remove dust cap, cotter pin, locking device (if present), nut and
flat washer.
3. Wiggle and pull hub toward you to remove outer bearing cone
and carefully remove hub from spindle.
4. Use a soft metal punch or wooden block to remove rear seal and
bearing cone and both bearing cups from hub.
5. Thoroughly clean hub and spindle.
6. Tap new bearing cups into place. A wooden block may be helpful.
Be certain they go in straight and are firmly seated into the hub.
7. Pack new bearing cones with grease and place one cone in
rear of hub.
8. Gently tap new grease seal into hub with a wooden block.
9. Put some extra grease in hub and carefully place hub on spindle.
Install new outer bearing cone.
10. Replace washer and nut and adjust as follows. With hub rotating,
tighten nut snug to insure that all parts are properly seated.
Back off the adjusting nut so hub will turn freely but there is no
significant rattle in the bearings. Reinstall any locking device and
install the cotter pin and dust cover.
11. Replace wheel if previously removed and double check to make
sure that wheel turns freely, but does not rattle.